Motor Rotation Instructions; Getting Started - BLAZE 42 Mode D'emploi

Install the two grease trays in the frontand back
of the unit When installed, these trays will
accept the grease filters on the bottom side The
front grease tray will provide a barrier between
the filters and the control knob connections The
rear grease trays install in the rear channel at
the back of the unit
Note: When installing the drip trays, place each tray
in the opening at the front and rear as shown in the
drawing
Be sure to have the small front bend hook over
the lip of the opening
step 6
Install all grease filter handles to the filters using the included screws Three filters
cover the front section of the hood and three cover the back Install the filters leaving
the bottom of the filters resting in the previously installed grease trays and the tops will
lay in the U shaped channel in the center support All filters must be installed from the
center position, and then moved to the left and right, leaving the center positioned
filter for last
Electrical Requirements - Hood comes with 4 foot cord, and will plug into a 110V
outlet which should be wired to a 15 AMP breaker

Motor Rotation Instructions

Getting Started

The image to the right shows the position of
the motors directly from the factory This
position of the motor is used when running
vertical
|
pipe for your venting
Step 1: Remove Cover Plate
There are two sets of screws you will
be working with on the cover plate
The smaller screws closest to the
edges of the plate hold the plate to the
hood itself The larger screws closer to
the center hold the motor to the cover
plate Remove all of the smaller screws
holding the cover plate to the hood
body
Step 2: Remove Motor Screws
Next, remove all of the larger screws that hold the motor to the
cover plate leaving the center screw The center screw to be left
in place can be seen in the image
Step 3: Detach motor from plate
Holding the center of the motor, remove the final screw, which
will free the motor from the cover plate Lower the motor gently
until it comes to resting position
Step 4: Rotate Motor
At this point, the cover piece can be removed and you are ready
to rotate the motor to the horizontal discharge position When
lifting the motor out of the housing, tilting the motor down on
one side is typically the best method for getting the motor out of
the opening
Once out of the hood, simply rotate 180 degrees and place the
motor back into the hood For both the removal and
reinstallation of the motor, be careful not to pinch the wiring
Allow it to rest at the initial position when you started
BLAZE OUTDOOR PRODUCTS
USER MANUAL |