Permissible Cutting Area And Danger From Kickback Or Pinching - Norton Clipper CP512-300 Traduction De La Notice Originale

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Diamond cut-off wheels are only approved for cutting mineral materials. When installing the diamond
cut-off wheel, always observe the rotating direction indicated on the diamond cut-off wheel; otherwise, the
cutting effect will reduce quickly from diamond loss.
Rotating direction of the cut-off wheel in the installed condition:  Chap. 5.1, page 16
Abrasive resin cut-off wheels must not be exposed to moisture. The water connection for wet cutting must
not be used when using abrasive resin cut-off wheels. Abrasive resin cut-off wheels must not be used in
high humidity or in rain. Only use abrasive resin cut-off wheels until the end of the best-before date
imprinted on the receptacle ring of the cut-off wheel.
The power tool's spindle is designed for cut-off wheels with an inner bore of 20 mm.
Cut-off wheels with a 1" inner bore must only be installed with the spindle adapter disk supplied with the
power tool.
Installation of cut-off wheels with 1" inner bore:  Chap. 5.2, page 17
Cut-off wheels with other inner bores must not be installed! Never modify the bore of the cut-off wheel!
New cut-off wheels must be tested for at least 60 seconds at the indicated maximum speed before the first
cutting process. No body parts must be located in the extended swivel range of the cut-off wheel.
7.2

Permissible cutting area and danger from kickback or pinching


ok
Danger of injury from kickback!
Kickback results when the upper part of the cut-off wheel is used for cutting.
The power tool is pushed towards the user's head uncontrolledly and at high speed.
 Never cut with the upper area of the cut-off wheel!
 Take special care at insertion into cutting areas already started!
Danger of injury from pinching!
Pinching results when the cutting point becomes more narrow (crack or tensioned work piece).
The power tool is accelerated forwards uncontrolledly and under high energy.
 Always perform cutting and repeated insertion into cutting points already started at the maximum speed.
 Always support the work piece so that the cutting point is under tension so that the cut-off wheel is not
clamped when cutting any further.
 When starting cutting, carefully move the cut-off wheel to the work piece; do not apply it suddenly.
 Never cut several work pieces at once!
 Ensure that no other work piece is touched when cutting.
The upper part of the cut-off wheel must not
be used for cutting!

Only the lower part of the cut-off wheel must
be used for cutting!
Power tool use
ENGLISH 27

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Clipper cp514-350Clipper cp512-300iClipper cp514-350i

Table des Matières