Reset Settings - Num'axes PIE1035 Guide D'utilisation

Set the time and date is important to ensure some parameters work as expected (Photo Stamp and Timelapse for
example).
8.10. Timelapse Interval
You have to set this parameter only if you have elected TIMELAPSE mode.
This function works only in TIMELAPSE mode.
The camera will take photos automatically at the programmed interval (the PIR sensor will be turned off).
Example: if programmed interval is 30 minutes, the camera will take photos automatically every 30 minutes.
8.11. Timelapse Period
You have to set this parameter only if you have selected TIMELAPSE mode.
This function works only in TIMELAPSE mode.
Allows you to select the start time and end time of the block of time during which the camera will work (the PIR
sensor will be turned off). Each day, the camera will work only during the time period user set.
Example: if start time is 15:00 and end time is 18:00, each day, the camera will work only between 15h00 (03:00 PM)
and 18h00 (06:00 PM).
The start time of this setting must be bigger than the current system time.
8.12. Serial NO. (camera ID)
This parameter allows you to set an ID number for the device (4 digits). This function can help you to identify from
where and from which camera the photos are. The serial number will appear at the bottom of the photos if the
PHOTO STAMP parameter is set to ON.
8.13. Format
This parameter allows you to delete all the files stored on the memory card to prepare it for reuse.
Select YES to format the SD card.
Caution: the deleted files can't be restored. Make sure you have downloaded or backed up any files you want to
preserve first.

8.14. Reset Settings

Select YES to restore all parameters to the original factory settings (default settings).
PIE1035 - Indice D – Octobre 2020
15 seconds | 30 seconds | 1 minute | 3 minutes | 5 minutes | 10 minutes |
15 minutes | 30 minutes
OFF
ON
OFF
ON
NO
YES
NO
YES
18/56