Num'axes PIE1035 Guide D'utilisation page 15

-
Remove the batteries if you are not using the device for a long time. Never leave discharged batteries in the
unit. They could leak and damage your product.
6. External power supply
The device can be powered by an external power supply (adaptor).
Specifications of the external power supply: Input AC 100V-240V/50-60Hz – Output DC 6V/2A
Before using an external power supply, you have to remove all the batteries from the device.
7. TEST/ON/OFF
TEST | Setting of the operating parameters
-
Slide the switch in the TEST position. Indications will appear on the LCD screen
-
Press the DOWN button to enter the setting menu.
-
Use the UP and DOWN buttons to navigate the operating parameters.
-
Press OK to enter the parameter you wish to set.
-
Use the UP and DOWN buttons to navigate the available settings for the chosen parameter.
-
Press OK to confirm the setting and exit.
TEST | Manual capturing
-
Slide the switch in the TEST position.
-
Press the UP button, the device starts to take photos. The
-
Press OK, the device will switch from the Photo mode to the Video mode and start to record videos. The
symbol will appear on the screen.
ON
-
After setting the operating parameters according to your preferences, slide the switch in the ON position.
-
The screen will light up then a countdown of 10 seconds will start. After 10 seconds, the screen will go out
and the device will operate according to the selected settings.
OFF
-
Slide the switch in the OFF position.
-
If you want to restart the camera, it will take 3 seconds after shutdown.
8. Configuration of operating parameters
-
Slide the switch in the TEST position. Indications will appear on the LCD screen.
PIE1035 - Indice D – Octobre 2020
WARNING
Make sure to follow polarity
indicated inside the battery
compartment
symbol will appear on the screen.
15/56