Hotpoint Ariston A6V530/EX Mode D'emploi page 8

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

GB
H05RR-F 4x4 CEI-UNEL 35363
H05VV-F 4x4 CEI-UNEL 35746
H05RR-F 5x2.5 CEI-UNEL 35363
H05VV-F 5x2.5 CEI-UNEL 35746
• Secure the power supply cable by fastening the cable
clamp screw then put the cover back on.
Connecting the supply cable to the electricity mains
Install a standardised plug corresponding to the load
indicated on the appliance data plate (see Technical data
table).
The appliance must be directly connected to the mains
using an omnipolar switch with a minimum contact opening
of 3 mm installed between the appliance and the mains.
The switch must be suitable for the charge indicated and
must comply with current electrical regulations (the earthing
wire must not be interrupted by the switch). The supply
cable must be positioned so that it does not come into
contact with temperatures higher than 50°C at any point.
Before connecting the appliance to the power supply, make
sure that:
• The appliance is earthed and the plug is compliant with the
law.
• The socket can withstand the maximum power of the
appliance, which is indicated by the data plate.
• The voltage is in the range between the values indicated
on the data plate.
• The socket is compatible with the plug of the appliance.
If the socket is incompatible with the plug, ask an
authorised technician to replace it. Do not use extension
cords or multiple sockets.
! Once the appliance has been installed, the power supply
cable and the electrical socket must be easily accessible.
! The cable must not be bent or compressed.
! The cable must be checked regularly and replaced by
authorised technicians only.
8
All manuals and user guides at all-guides.com
400V 2N~
N
L2 L1
400V 3N~
N
L3
L2
L1
! The manufacturer declines any liability should these
safety measures not be observed.
Data plate, is located inside the flap or, after the oven
compartment has been opened, on the left-hand wall
inside the oven.
TARGHETTA CARATTERISTICHE
Dimensioni
32x43,5x40 cm
Forno HxLxP
lt. 58
Volume
larghezza cm 42
Dimensioni utili
profondità cm 44
del cassetto
altezza cm 8,5
scaldavivande
Tensione e
vedi targhetta caratteristiche
frequenza
d'alimentazione
Piano di cottura
in ceramica
Anteriore sx
1700 W
Posteriore sx
1200 W
Posteriore dx
2300 W
Anteriore dx
1200 W
Assorbimento
piani di cottura
in ceramica Max
6400 W
Direttiva 2002/40/CE
sull'etichetta dei forni elettrici.
Norma EN 50304
Consumo energia convezione
Naturale – funzione di
ENERGY
riscaldamento:
LABEL
Consumo energia dichiarazione
Classe convezione Forzata -
funzione di
riscaldamento:
Questa apparecchiatura è
conforme alle seguenti Direttive
Comunitarie: 73/23/CEE del
19/02/73 (Bassa Tensione) e
successive modificazioni -
89/336/CEE del 03/05/89
(Compatibilità Elettromagnetica)
e successive modificazioni -
93/68/CEE del 22/07/93 e
successive modificazioni.
2002/96/CE
La targhetta caratteristiche e' situata all'interno della
ribaltina oppure, una volta aperto il cassetto scaldavivande,
sulla parete interna sinistra.
IT

Tradizionale;

Multicottura.

Publicité

Table des Matières
loading

Table des Matières