Noise/Vibration Information; For Your Safety; Intended Use - Bosch GWS 14-125 C Instructions D'emploi

Noise/Vibration Information

Measured values determined according to
EN 50 144.
Typically the A-weighted noise levels of the prod-
uct are: sound pressure level: 88 dB (A); sound
power level: 101 dB (A).
Wear ear protection!
The typical weighted acceleration is 5.0 m/s

Intended Use

The machine is intended for cutting, roughing and
brushing metal and stone materials without using
water. For cutting stone, a cutting guide is re-
quired.
For machines with electronic control: With ap-
proved sanding tools, the machine can be used
for sanding and polishing.
Information Structures
Slots in load carrying walls are subject to the
Standard DIN 1053, Part 1 or country-specific
regulations.
These regulations are to be observed under all
circumstances. Before beginning work, consult
the responsible structural engineer, architects or
the construction supervisor.
1 609 929 599 • TMS • 17.01.01
All manuals and user guides at all-guides.com
2
.
English - 2

For Your Safety

Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed. In addition, the
general safety instructions in the
enclosed booklet must be fol-
lowed. Before using for the first
time, ask for a practical demon-
stration.
If the mains cable is damaged or
cut through while working, do not
touch the cable but immediately
pull the mains plug. Never use the
machine with a damaged cable.
Wear protective glasses and ear
protection.
The dust that is produced while
working can be detrimental to
health, inflammable or explosive.
Suitable safety measures are re-
quired.
Examples: Some dusts are re-
garded as carcinogenic. Use suita-
ble dust-/chip extraction and wear a
dust mask.
Dust from light alloys can burn or
explode. Always keep the work
place clean, as blends of materials
are particularly dangerous.
Wear protective gloves and sturdy
shoes.
When necessary, also wear an
apron.
Connect machines that are used in the open
via a residual current device (RCD) with an ac-
tuating current of 30 mA maximum. Use only
extension cables that are approved for outdoor
use.
When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
Always direct the cable to the rear away from
the machine.
Always switch off the machine and allow to
come to a stop before placing it down.