Trim Adjustment - XciteRC 3i FHSS Hobby-Spec Mode D'emploi

Operation
other side the max. position will be set.
4. Throtthle (brake side)
Adjusting the potentiometer TH.BR, in 0 position shown the min. value 0% (servo did not rotate), on the
other side the max. position will be set.
NOTE: when adjusting this function, make sure the direction is in agreement with the models direction,
otherwise use the servoreverse function.
WARNING: adjust EPA always so that the servo travel is not mechanically limited to the model (eg by
hitting the steering arm), but always on electronically on the transmitter! Otherwise, your servos will not last
long.

Trim adjustment

1. Connect the receiver, servos, and other components and then turn on the power switches to transmitter
and receiver.
2. Be sure the Steering trim and Throttle trim on the transmitter are at their neutral position.
Steering Trim (ST.TRIM)
Steering neutral adjustments can be made by moving the steering trim knob to the left or the right. The
ST.DR-LED shows the trim position.
Flash
left
Racers-Tip: Always check and be sure the servo is at its neutral position before installing a servo. Ad-
just the servo horn hole position and linkage so both are parallel. When a servo saver is used place it
as closer to center position as possible. Be sure the steering trim on the transmitter at the neutral position.
Trim Operation And Maximum Trav: Changing the trim can effect the overall settings, when adjustments are
made with the trims, please recheck your installation for maximum servo travel (ST.D/R).
Throttle Trim (TH.TRIM)
Throttle neutral adjustments can be made by moving the throttle trim to the left or the right. The ST.DR-LED
shows the trim position.
XciteRC 3i FHSS Hobby-Spec 2.4 GHz
All manuals and user guides at all-guides.com
NOTE:
When find the direction is wrong, you can change it with the servo
reverse switch!
1. When adjust the trim button, the ST.DR-LED appears green flash.
2. When in the neutral position, the ST.DR-LED appears red.
3. When in max. position, the ST.DR-LED appears flashing red,
then all appears.
right
EN
19