Set Flash - Geemarc JUPITER 4 Notice D'utilisation

- Press OK button to confirm and enter the next digit setting.
- When the area code has been set (6 digits length), press OK button once
to enter the long distance code (LDS CODE) setting (4 digits length).
- The LCD displays SET LDS CODE.
- Use or button to select the first digit of the LDS code. If the long
distance code is 01, then the first two digits must be left blank. To insert a
blank, press OK.
- Press OK button to confirm and enter the next digit setting.
- Press X button to exit to the standby mode.

2.7 - SET FLASH

- After entering the SET FLASH menu, press OK.
- Use or button to select the flash time (100ms/300ms/600ms).
- Press OK button to confirm.
(In the UK, the default value is 100ms, in France, the default value is
300ms.)
- Press X button to exit to the previous menu.
2.8 - DIM: X- - ->X
- After entering the DIM: X--->X menu, press OK.
- Use or button to select ON/OFF to activate/deactivate the
DIM: X- - ->X function.
- Press OK button to confirm. (The default mode is ON)
If the DIM: X- - ->X function is activated, the maximum number of digits that
can be shown on the LCD is 18 small digits.
If the DIM: X--->X function is not activated, the maximum number of digits
SETTING UP
10