Cleaning And Care; Maintenance And Storage; Topping Up The Hydraulic Oil / Greasing; Removing Air From The Hydraulic System - ULTIMATE SPEED CRIC HYDRAULIQUE Instructions D'utilisation Et Consignes De Sécurité

CAUTION! Lower the vehicle slowly, other-
wise there is the danger of injury and damage
to the product or to the vehicle.
j
First raise the vehicle slightly in order to be able
to remove the axle stands. Proceed as described
in the section on „Raising the vehicle".
j
Remove the axle stands.
j
Place the rod with oval opening on to the
7
release valve and turn the rod slowly anti-
5
clockwise (Fig. C). The vehicle is lowered slowly.
Note: The more quickly the rod
anticlockwise, the faster the vehicle is lowered.
Therefore you should proceed very cautiously
at first in order to get a feeling for the correct
speed.
j
Lower the support plate
loaded. Then pull the vehicle jack out from
under the vehicle. Press down on the support
plate until it is fully lowered.
1
j
Close the release valve
on the release valve
j
Take the rod off the release valve
7
j
If it is extended, screw the extension screw
back down into the jack body.

Cleaning and Care

Q
j
L iberally grease all external moving parts.
j
C lean the hydraulic trolley jack using a slightly
oily cloth.
j
N ever use harsh or corrosive cleaning agents.

Maintenance and storage

Q
Topping up the
Q
hydraulic oil / greasing
Note: Use only hydraulic oil that complies with
ISO VG 15.
j
Stand the vehicle jack upright on a level, flat
surface.
j
Screw the extension screw
down into the jack body.
is turned
7
until it is no longer
1
by turning the rod
5
clockwise.
5
.
5
2
completely
2
j
Place the rod
release valve
(Fig. C) until the support plate
j
Pull the oil plug
j
Introduce hydraulic oil from a suitable vessel into
the oil reservoir. Fill the hydraulic oil reservoir
up to the bottom edge of the filling opening.
j
Remove any air present in the hydraulic system.
To do this follow steps 3 - 4 in section on
"Removing air from the system".
j
Replace the oil plug
voir opening.
j
Grease all moving parts on the vehicle jack
regularly to prevent corrosion.
j
Top up with approximately 100 – 105 ml oil if
all the oil has been used up.
Removing air from
Q
the hydraulic system
7
Air in the hydraulic system may detrimentally affect
the proper functioning of the vehicle jack.
Proceed as follows to remove air from
the hydraulic system:
1. Place the rod
release valve
(Fig. C) until the support plate
2. Pull the oil plug
3. Guide the lifting handle
handle socket
several times to allow any air to escape.
4. Place the rod
release valve
(Fig. C). The release valve
again.
5. Replace the oil plug
voir opening.
6. If necessary, repeat steps 1 - 5 until all the air
has escaped.

Storing

Q
j
Place the rod
release valve
with oval opening on to the
7
and turn the rod anticlockwise
5
is fully lowered.
1
out of the oil reservoir.
8
back into the oil reser-
8
with oval opening on to the
7
and turn the rod anticlockwise
5
is fully lowered.
1
out of the oil reservoir.
8
into the lifting
6
and pump it up and down
3
with oval opening on to the
7
and turn the rod clockwise
5
is now closed
5
back into the oil reser-
8
with oval opening on to the
7
and turn the rod anticlockwise
5
GB/IE 7