Breville ikon Hemisphere BBL600XL /C Mode D'emploi page 6

BBL600XL_IB_p10-p11.pdf 1 16/03/11 11:27 AM
Operating your Breville ikon
Hemisphere LCD Blender
TM
Step 10.
For ingredients that require short bursts of power,
select the 'PULSE' function. The 'PULSE' button will
illuminate and remain illuminated while the button is
pushed. When this function is selected, the LCD timer
screen will illuminate and count upwards in one
second increments during pulsing. Press the 'PULSE'
button in short bursts until blending is complete.
Use the 'PULSE' button when the food that is
being processed is too thick or coarse to
circulate within the blender pitcher.
Note
Step 11.
At the end of use, always make sure the Breville ikon
Hemisphere™ LCD Blender is turned off by pressing
the 'Power' button on the control panel and then
unplug the cord. Make sure the motor and blades
have completely stopped before attempting to move
the appliance, or when the Breville ikon Hemisphere
LCD Blender is not in use and before disassembling,
leaning and storing.
10
continued
• During the blending process, ingredients may
stick to the sides of the blender pitcher. To
push the food back onto the blades, press the
'Power' button on the control panel and
remove the power cord. Remove the lid and
use a plastic spatula to scrape down the sides
of the pitcher. Replace the lid before
recommencing blending.
• If any moisture or liquid appears on top of the
motor base during blending, press the 'Power'
button on the control panel and remove the
power plug. Remove the blender pitcher. Wipe
the motor base immediately with a dry cloth or
paper towel to absorb the liquid. Check that
the blender pitcher is correctly assembled.
TM
Disassembling your blender for cleaning,
care and storage
Step 1.
Always make sure the Breville ikon Hemisphere
LCD Blender is off by pressing the 'Power' button on the
control panel. Then unplug the power cord.
Step 2.
Remove the blender pitcher from the motor base
by grabbing the handle and lifting the jug in an
upward direction.
Step 3.
Remove the blade assembly by turning over the blender
jug and twisting the Blade Removal System clockwise to
unlock, (see Fig 1) then lift upwards and away from the
Note
base of the blender jug. The circular plastic surround
attached to the base of the blender jug is not removable.
Step 4.
Use care handling the blades. Remove the silicon seal
from the blade assembly. Place the blade holder on the
counter-top with blades upward. Grip the lower half of
the blade holder around the outer wall and press
downwards in a sharp movement. The two parts will
separate with a click.
The Breville ikon Hemisphere
features a Two-Part Blade Assembly System for
the easy removal of the blade and jug for cleaning.
Fig 1
TM
Notch
LCD Blender
TM
Note
Notch
11