BH FITNESS G6522 Instructions De Montage Et Utilisation page 15

4 Position the left and right base
covers (63) and (64) in the direction of
the arrow facing the corresponding
side bar, as shown in Fig.3.
FITTING THE MONITOR:
5 Connect the control cable terminal
(37) Fig.4, coming out of the monitor, to
the control cable (36), sticking up from
the right-hand side bar (4), and insert
screws (16), making sure not to pinch
the cables, and tighten the 4 screws
(16) fully.
6 Position the left and right base covers
(63) and (64) in the direction of the
arrow facing the corresponding side bar,
as shown in Fig.5 and attach them by
using screws (22) (23), as shown in
Fig.5.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (76),
Fig.6
The treadmill has to be moved as
shown in Fig.6. Even though this can
be done by one person it is advisable
that two people are involved due to
the weight of the machine. It is very
important to grip of the machine, it
must never be
bygrabbing the electronic monitor.
Once the machine is in an ideal spot
for use, lower it gently down onto the
floor.
To prevent accidents DO NOT move
the treadmill across uneven floors.
MAINTENANCE.-
Use the bottle of lubricant (127) to
lubricate the inside of the belt in order to
keep your unit in top condition and to
ensure that friction between the belt and
the board Fig.7 is kept to a minimum
(due to different running styles, always
apply more lubrication to the area where
All manuals and user guides at all-guides.com
moved about
15
you place your feet during the exercise).
It is advisable to lubricate the base of
the belt between the board and the
band every month, depending on how
often it is used.
Measurement Speed
6KM/hr below 1 year
Metric 6~12KM/hr
12KM/hr above 3 moths
4mile/hr below 1 year
English 4~8mile/hr
8mile/hr above 3 moths
Note: This preventive maintenance
schedule is only meant for home use.
It is suggested to maintain the unit
every month for commercial use.
If the belt starts to slip after lubrication,
then check the tension of the belt. To
tension the belt, take the 6mm Allen
key and with the machine set to 4km/h
turn screws (R & L) one turn in a
clockwise direction.
ADJUSTING THE BELT.-
If your unit is not seated evenly on the four
contact points, this may cause the belt (X)
to shift sideways. Rigorous quality control
adjusts and checks the running belt.
However, due to weight differences and
individual styles of running, the belt may
be prone to shift sideways.
If the belt does shift to the left or right, stop
the machine.
BELT OFFSET TO THE RIGHT.-
This procedure is very important. Follow
these steps. In order to adjust the belt, set
the unit in motion at a speed of 4km/h. If
the belt has moved to the right, turn screw
(R) on the right-hand side of the machine
a 1⁄4 turn clockwise. Note the position of
Interval
6
months
6
months