Before Returning For Repairs; Specifications - DSR Industrial Série Guide D'utilisation

PROBLEM
Charger makes a loud buzz
or hum.
CHARGING (yellow) LED is
blinking.
The battery is connected and
the charger is on, but is not
charging.
The measured current is
much lower than what was
selected.
15.

BEFORE RETURNING FOR REPAIRS

15.1 When a charging problem arises, make certain that the battery is capable of accepting
a normal charge. Double check all connections, the AC outlet for a full 120-volts, the
connector for correct polarity and the quality of the connections from the cables to the
connecotr and from the connector to the battery system. The connections must be clean.
15.2 When a battery is very cold, partially charged or sulfated, it will not draw the full rated
amperes from the charger. It is both dangerous and damaging to a battery to force
higher amperage into it than it can effectively use in recharging.
15.3 When an UNkNOWN OPERATING PROBLEM arises, please read the complete manual
and call the customer service number for information that will usually eliminate the need
for return.
If the above solutions do not eliminate the problem or for information about troubleshooting, call
16.

SPECIFICATIONS

Nominal Operating Voltage (VAC)
Input Current
Output Power (W)
Output Current (A max)
Output Voltage (VDC / maintain)
Case
Dimensions (inches)
Weight
POSSIBLE CAUSE
Transformer laminations
vibrate (buzz).
Shorted Diode Assembly or
Output Rectifier Assembly
(hum).
Indicates the charger is in
abort mode.
Connector is not making a
good connection.
The charger reached the
maximum voltage and is
reducing the current.
toll-free from anywhere in the U.S.A.
7:00 am to 5:00 pm Central Time Monday through Friday
1-800-621-5485
Electrical
Mechanical
Steel with Baked Enamel Finish
11 L x 9½ W x 10 ¼ H
40 lbs
• 8 •
REASON/SOLUTION
No problem, this is a normal
condition.
Have charger checked by a
qualified technician.
See "Abort Mode" in the
OPERATING INSTRUCTIONS
Section.
Check for poor connection at
battery. Make sure connecting
points are clean. Rock
connector back and forth for a
better connection.
No problem, this is a normal
condition.
120
13.5A
900
25
46.2 / 39.6