Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
7. Installation
Proceed as follows when installing the camera.
1.
Select a suitable place on the ceiling of the room where you would like
to mount the camera.
2.
Connect the video cable (recommended cable type: RG59) to the BNC
video out (1) of the camera and to the following connected video unit.
The maximum cable length should not exceed 150 m.
3.
Connect a 12 VDC power supply to the power input of the camera (2).
4.
Hold the camera at the location where you want to mount it. Check the
orientation and angle of the camera.
5.
Change the orientation of the camera module if necessary by
loosening the fixing screw (4), modifying the inclination of the camera
module (3), and then tightening the fixing screw again.
6.
Fasten the camera in the smoke detector housing to the desired
installation location using the supplied screws (5).
Products which are labeled with this pictogram may not be
disposed by the domestic rubbish.
Please dispose the product in accordance with the prevailing
legal regulations at the end of its life time.
Please consult your dealer or dispose the product over the
municipal gathering point for electric scarp
15
Publicité
Table des Matières
