Amana ACD12JE-E Guide D'utilisation Et D'entretien page 10

Med—for normal cooling
■
Low—for minimum cooling
■
NOTE: After 5 seconds, the display will show the current room
temperature.
Temperature
Press the TEMP/TIME up arrow button to raise the
■
temperature. Each time you press or hold the TEMP/TIME
up arrow button, the temperature will go up 2ºF (1ºC) until it
reaches 86°F (30°C).
NOTE: After 5 seconds, the display will show the current room
temperature.
Press the TEMP/TIME down arrow button to lower the
■
temperature. Each time you press or hold the TEMP/TIME
down arrow button, the temperature will go down 2ºF (1ºC) until
it reaches 61°F (16°C).
NOTE: After 5 seconds, the display will show the current room
temperature.
Timer Delay
To set the Timer for a 1-hour to 24-hour delay until the air
conditioner turns off (the air conditioner must be On):
1. Press TIMER. Timer OFF indicator light will flash. Display will
show remaining hours before the air conditioner will turn off.
2. Press the TEMP/TIME up or down arrow button to change the
delay time from 1 hour to 24 hours.
3. After 5 seconds, Timer OFF indicator light will remain on.
Display will show the current room temperature.
To set the Timer to turn on the air conditioner, keeping
previous settings:
1. Turn off the air conditioner.
2. Press TIMER. Timer On indicator light will flash. Display will
show remaining hours before the air conditioner will turn on.
10
All manuals and user guides at all-guides.com
3. Press the TEMP/TIME up or down arrow button to change the
delay time from 1 hours to 24 hours.
4. Timer On indicator light will remain on.
To set the Timer to turn on the air conditioner, changing
the previous settings:
1. Turn on the air conditioner.
2. Adjust the mode to Fan, Cool, Energy Saver or Dehum.
3. For Fan, Cool or Energy Saver mode, adjust the fan speed to
High, Med or Low.
4. Adjust the temperature between 61ºF and 86ºF (16ºC and
30ºC).
NOTE: In Fan mode, the temperature cannot be set.
5. Wait 3 seconds before turning off the air conditioner.
6. Press TIMER. Timer On indicator light will flash. Display will
show remaining hours before the air conditioner will turn on.
7. Press the TEMP/TIME up or down arrow button to change the
delay time from 1 hours to 24 hours.
8. Timer On indicator light will remain on.
To clear Timer delay program:
NOTE: Air conditioner can be either on or off.
1. Press TIMER once after it has been programmed. Display will
show remaining time.
2. While the display is showing the remaining time, press TIMER
untill Timer indicator light turns off.
To see or change the remaining time (in hours):
1. Press TIMER once after it has been programmed. Display will
show remaining time.
2. While the display is showing the remaining time, press the up
or down TEMP/TIME button to increase or decrease the time.
3. After 5 seconds, the display will show the current room
temperature.
UV Light Air Purifier
The photo catalytic air purification system cleans, deodorizes
and purifies the interior air by using a filter treated with titanium
dioxide. A small UV LED light positioned over the filter activates
the titanium dioxide coating and produces a cleansing reaction
similar to that of sunlight. This reaction converts oxygen and
water into hydroxyl-free radicals that cleanse the air.
NOTES:
To turn on the UV Light air Purifier, press the UV Light icon on
■
the remote control. See "Using the Remote Control."
It is recommended that the UV Light filter be cleaned yearly.
■
See "Air Conditioner Care."