Philips MZ-5 Mode D'emploi page 10

XP MZ5/37 15-04-2002 13:14
General information Power supply
Speaker connections
The speaker terminals are click-fit connectors.
Use them as shown below.
R
AUX in
8 Ω
LEFT
–
RIGHT
–
• Connect the marked red wire to the red
terminal and the unmarked wire the black
terminal.
• When headphones are inserted into the
headphone jack the speakers are disconnected.
Power supply
1 Check if the power voltage, as shown on the
type plate located on the bottom of the
set, corresponds to your local power voltage. If it
does not, consult your dealer or service center.
2 If your set is equipped with a voltage selector on
the bottom of the set, adjust the selector so that
it matches with the local power voltage.
3 Connect the power plug to the wall outlet and
the set is now ready for use.
➜ The clock display ··· : ··· flashes.
4 To disconnect the set from the power
completely, remove the plug from the wall outlet.
Power-saving automatic standby
As a power-saving feature, the unit automatically
switches to standby if:
– 15 minutes after a CD has reached the end
and no control is operated.
– after more than 24 hours no controls are
operated.
10
Pagina 10
L
speakers
LEFT
+
RIGHT
+
Safety information
• Place the set on a hard and flat surface so that
the system does not tilt. Make sure there is
adequate ventilation to prevent the system from
overheating.
R
• The mechanical parts of the set contain self-
lubricating bearings and must not be oiled or
lubricated.
AUX IN
You can connect the audio left and right OUT
terminals of another sound system, e.g. CDR,
cassette recorder to the corresponding left and
right AUX IN terminals at the rear of the set.
• Use the MZ-5 sound controls to adjust the
sound of the other system.
• For playback of a connected CD-R(W), select
the CD-R(W) source.
Connections