Energy Saving - Carrier My-Comfort NTC Manuel De L'utilisateur

NTC – My comfort controller
Use of the remote control
Lights control (button B)
If enabled, the following is the display visualization with system off
(Unoccupied mode).
on
1
off
If, during installation, several light groups are selected, their
number is displayed between the "1" and "A" icons which are
always present. The following figure shows an example where 3
light groups are selected (a maximum of 4 groups is allowed).
on
1
off
Press button B to start surfing inside the menu. The first group "1"
starts flashing. Keep pressing button B until the desired group is
selected (flashing). To switch on the lights of this group, direct the
remote control towards the unit and press button C or D. To switch
off the lights, repeat the same operations but press button C or F.
To operate all the lights select option "A".
The icon "on" or "off" flash for 3 seconds together with the selected
group to confirm switching on or off. After 3 seconds the message is
sent to the unit.
on
1
off
Blinds control (button B)
If enabled, select the menu before operating the blinds. Press
button B until the following configuration is displayed:
1
If no button is pressed within 180 seconds the system quits the
menu automatically. If several groups of blinds are selected, the
group corresponding number is displayed between icon "1" and "A"
which are always present.
Press button B to surf within the menu.
It follows an example of 2 selected groups of blinds.
1 2 A
Fig. 10
GB - 6
All manuals and user guides at all-guides.com
A
Fig. 6
2 3 A
Fig. 7
2 3 A
Fig. 8
A
Fig. 9
1 2 A
Fig. 11
Once the desired group of blinds is selected by the user (it must
flash), direct the remote control towards the unit and press button D
to raise the blinds of that group, or button F to lower the blinds.
This operation is displayed as shown in fig. 11. Once back to this
menu, the last modified group of blinds flashes.
Blind inclination (button B)
By following the instructions above to select the desired group, it is
also possible, if enabled, to establish the blinds inclination. To do
so, press button C until the blind reaches the desired inclination.
This time, both arrows are flashing on the display:
1 2
1
The different inclinations are shown on
2
the right.
3
4
5
Selecting the fan speed
(button E)
The fan speed can be selected by pressing button
Indicated symbol
Low speed
(for night operation)
Medium speed
High speed
(at start-up, to reach temperature)
Automatic (fan speed will automatically switch to the
value required for optimum comfort).
If the unit is equipped with a variable speed motor, the selectable
speeds are 2: Auto and High.

Energy saving

The Energy saving function is enabled if the remote control is not
used for more than 30 minutes consecutively. All icons on the
display are switched off and the following configuration is set:
If any key is pressed, the system goes back to the configuration
shown in fig. 2 only if the lights have been set in the remote control
menu. If not, the last configuration before activation of this function
is displayed.
A
Fig. 12
.
Fig. 13