Panasonic CF-VDL02 Mode D'emploi page 10

Touchscreen
Configuring the Touchscreen
When needed, the touchscreen can be configured using the following steps.
1
Windows 2000
Select from the taskbar or select [Settings] from [Start] - [Programs] - [UPDD]
Windows XP
Select from the taskbar or select [Settings] from [Start] - [All Programs] - [UPDD]
The following screen will be displayed.
Events
Set the events that can be generated by a
controller.
Devices
Configure the device controller.
E
Hardware
Set the hardware resources.
Match this setting with the set-
ting for [Touch Screen] in the
Setup Utility.
Settings
Set the general protocol
settings.
NOTE
For more information, refer to [Help].
2
Make necessary changes
3
Select [OK]
NOTE
Adjustments can be made when double-click operations are assumed by the computer although single-click operations
are intended, by clicking [Windows] from the display shown above and decreasing the value for [Time] in [Double
Click Settings].
Immediately run [Calibrate] when the number of points of calibration is changed.
It is also possible to change the double click speed for [Tap and Buttons]*.
It is important to note that when the double click speed for [Mouse] is changed, the double click time for [Windows] is
also changed.
* Windows 2000
Windows XP
<For CF-M34 series only>
You can use the touchscreen without changing the settings when the LCD Monitor is connected to Serial Port B. To
connect to Serial Port A, select [Hardware] and set [Settings For] to [Device 2] and [COM port] to [COM 1].
<For the model with the Display Rotation Tool only>
Rotate the display to landscape mode (0 degrees) before performing the calibration.
10
All manuals and user guides at all-guides.com
Windows 98 Windows NT
Advanced
Set the advanced settings.
Windows 98 Windows NT : in [Start] - [Settings] - [Control Panel] - [Mouse].
: in [Start] - [Control Panel] - [Printers and Other Hardware] - [Mouse].
General
Set the general settings and functions.
Windows
Set the "double-click" settings.
Calibration
Define the calibration setup.
Use when the cursor can not be pointed
correctly with the finger or stylus. (Needed
if the alignment of the touchscreen with the
visual image change or adjust the display
resolution).
<Only for CF-M34 series>
Before you run the calibration, you need
to set the device at [Calibration settings
for] as followings.
[Device1] is for the computer
[Device2] is for the LCD Monitor
About
Display the version number.
Status
Display the status of the controller.