Thermador KBULT3651A Instructions D'installation page 19

Pour réfrigérateurs encastrés
Masquer les pouces Voir aussi pour KBULT3651A:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Install C ust om Pane ls
IMPORTANT: Thermador is not responsible for the removal or
addition of molding or decorative panels that would prevent the
refrigerator from being serviced.
NOTE: To install full-overlay custom panels, refer to the
installation instructions included with the Trimless Trim Kit. See
"Design Specifications" for more information.
Door and Drawer Panels
1. Remove all tape and door bracing from the refrigerator door
and freezer drawer.
2. Remove the screws that attach the handle to the frame.
3. Slide the decorative door panel into the frame.
4. If needed, route the door and drawer panels or install a filler
panel between the door and drawer and the decorative
panels. See "Custom Panels."
A. Door panel
B. Drawer panel
5. Replace the door and drawer handles. Check to be sure that
the door and drawer are aligned.
6. Remove the protective skin from the screw covers. Snap the
screw covers into the handle trim section.
All manuals and user guides at all-guides.com
A
Top Grille Panel
1. Grasp both ends of the top grille.
2. Push straight up; then pull straight out. Place the top grille
panel side down on a soft working surface.
3. Remove one end cap by loosening the nuts and sliding off the
end cap.
A. Bottom rail
B. Nuts
4. Slide the backer panel into the top grille channel and reattach
the end caps.
B
5. Replace the top grille in the cabinet side trims and pull the
panel down slightly to lock it into place.
B
A
A. Top grille
B. Cabinet side trim
C. End cap
D. Top rail
A. Backer panel
B
A
A. Top grille
B. Cabinet side trim
B
B
19

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Kburt3651aKbult3661aKburt3661aKbult3671aKburt3671a

Table des Matières