Pairing The Handset And Door Unit - Marmitek DOORPHONE 170 Guide Utilisateur

CAUTION: BE SURE THE BATTERY IN THE HANDSET IS A
RECHARGEABLE TYPE BEFORE YOU PLACE IT IN THE CHARGER
STAND, OTHERWISE AN EXPLOSION MAY RESULT.

PAIRING THE HANDSET AND DOOR UNIT

This process is to match the door unit with the handset so that they can
communicate with each other and so that no other devices (even a door
phone of an identical model) can interfere with you or the receiving of
your signal.
The door unit and handset are already paired with a factory pre-set code
when they are shipped from the factory. However, we recommend pairing
them again to achieve better privacy and to avoid a false triggering of a
door lock from a nearby door phone system.
To perform the pairing process, it is necessary to use alkaline batteries as
the power supply in the door unit, while the12V DC supply should be
disconnected temporarily.
1. Place the door unit and handset close to each other within a distance
of 1m.
2. Press and hold the talk/answer button
power ON/OFF button
(17) will show the following:
Flashing
Light up steady
3. Press and hold the pairing button (7) at the back of the door unit
while installing the alkaline batteries. The call indicator (4) will start
flashing after 3 sec, showing that the door unit has entered pairing
mode.
Perform the same for the door unit that is intended to be used at the
back gate (option, not included).
8
(15) to switch on the unit. The screen
(16), then long press the
© MARMITEK