INFLATE THE TIRES
The maximum tire pressure is indicated on the tires.
Remove the front and rear tire inflatable mouth cap.
•
Connect the pump to inflate and tight it to the inflatable mouth.
•
Replace the mouth cap when finish pumping.
•
SPECIFICATIONS
Max. continuous rated power: 250 W
•
Max. tire pressure: 2.4 bar
•
Max load: 120 kg
•
Min. height of user: 130 cm
•
Suitable age: 14+
•
The A-weighted emission sound pressure level at workstations, is less than 70dB(A)
•
The peak C-weighted instantaneous sound pressure value at workstations, is less than 63Pa
•
The A-weighted sound power level emitted by the machinery, is less than 80dB(A)
•
CARE & MAINTENANCE
WARNING! As with any mechanical component, a vehicle is subject to high stresses and wear. The
various materials and components may react differently to wear or fatigue. If the expected service
life for a component has been exceeded, it may break suddenly, therefore risking causing injuries to
the user. Cracks, scratches and discoloration in the areas subject to the high stresses indicate that the
component has exceeded its service life and should be replaced.
Your E-Scooter Pursuit will require regular maintenance. Please use following checklist to ensure
your E-Scooter runs smoothly for a longer time.
•
Charge your battery often. Avoid charging your battery for too long to avoid damage to it.
Always allow your battery to cool before charging to help increase your battery's life expectancy.
•
•
Avoid riding in wet conditions when possible, to avoid excessive exposure and corrosion.
•
Keep all moving components clean. Once a week, use a clean, damp cloth to wipe off dust and
grime that collected on the handlebars and stem. Wash the deck with lukewarm water and a bit
of dish soap. Take care not to get the electrical components wet. Let the components dry before
you use the scooter again.
•
Check your brakes, brake discs, and rotors for wear and tear on a weekly basis. Do not ride your
E-Scooter if the brakes don't respond properly.
Check your E-Scooter's tire pressure on a regular basis. Proper inflation helps you reach
•
maximum speed without taxing your motor.
•
Inspect all cables for wear and tear regularly. If you notice any damage to the cables or their
housing, they may need to be replaced.
The self-tightening nuts, as well as the other self-tightening fastenings, may lose their efficiency.
•
They may need to be retightened as follows: M4 bolt: 2.5~3.5 N/m - M5 bolt: 4~6 N/m - M6 bolt:
12~14 N/m - M7 bolt: 27~29 N/m.
If you're using your E-Scooter as your primary means of transportation, it is advised to contact
•
your reseller and schedule an annual inspection with a qualified maintenance shop.
•
Keep all joints and parts, such as brakes and hinges, lubricated. Please lubricate at least once
a month to keep the scooter in good condition. Please use lubricants designed for bicycles and
scooters.
•
Store your E-Scooter in a safe place (inside) to prevent damage to electrical parts or the battery.
Choose a location that's out of direct sunlight and in an area where temperatures are steady.
-8-