Before First Use - GUARDO Pursuit Mode D'emploi

BEFORE FIRST USE

Before using the E-Scooter for the first time, it is recommended to check if the battery is completely
charged. We recommend you to fully charge the battery before first use and read this manual
thoroughly.
Always verify if the E-Scooter has any damage before using it: check if the steering system is correctly
adjusted, that all connected elements are correctly tightened and that the brakes and tires are in
good condition. Damages could lead to incorrect usage or defects that can cause accidents.
ASSEMBLING
The E-Scooter is folded when placed in the box.
To unfold the E-Scooter, release the folding hook (9) from the folding bracket (12) and put the
•
front bar up until it clicks into place. The folding handle (4) has a lock button, this should be
unlocked by sliding it up. Then close the folding handle (4).
Note: To fold the E-scooter again for easy storage, unlock the lock button on the folding handle
(4) by sliding it down, release the folding handle (4) and pull the front bar down so that the
folding bracket (12) clicks on the folding hook (9).
• Install the crossbar on the front bar. Use the provided hex wrench to lock the screws on both
sides.
CHARGING
• Power off the vehicle when charging.
• Only charge the vehicle when it is located indoors.
• Put one side of the charging adapter cable into the charging port (5) of the E-Scooter.
• Place the other side of the charging adapter cable in a power outlet.
During charging, the indicator light of the charger is red. The indicator light turns green when
•
the battery is fully charged.
-5-