Klarstein DUKONO Mode D'emploi page 25

Switch heating on / off / quick start
Press the (+) or (-) button to start the heat setting directly (even if a
weekly program is set).
• Press either the (+) or (-) button to see the current temperature
on the screen.
• Press the (+) or (-) button to set the desired temperature. If the
set temperature is higher than the room temperature detected
by the device, the heating will start. The heater will not start if
the set temperature is lower than the room temperature.
Note: The temperature can be set between 10 °C and 30 °C. Select OFF to turn the
heater off.
Set high heat output
Press the D (MENU) button on the control panel, the display will
show H and the flashing heating symbol.
Press the OK button to set the temperature. The default temperature
is 10 ° C (50 ° F). The image at left will appear on the display.
Press the (+) or (-) button to set the temperature. If the set temperature is higher than the
room temperature detected by the device, the heating will start. If the set temperature is
lower than the room temperature, the heating will not start.
EN
25