Overload Protection - Wilfa Chill Connected AC1W-7000 Instructions

TIMER SETTING (1HOUR-24HOURS)
EN
The timer has two ways of operation:
To turn off
(When power
on)
To turn on
(When power
off)
Cancel timer

OVERLOAD PROTECTION

In the event of a power loss, to protect the compressor there is a 3-minute delay
until the compressor restarting.
DRAINAGE
SELF- EVAPORATING SYSTEM
The self-evaporating system uses the collected water to cool the condenser coils
for better, more efficient performance. There is no need to empty the drainage
tank in cooling mode, except in high humidity conditions. In drying mode, the
drainage tank needs to be emptied. The condensed water evaporates at the
condenser and disappears through the exhaust hose.
For continuous operation or unattended operating in drying mode, please
connect the attached drain hose to the unit. Condensed water can automatically
run into a bucket or drain.
• Switch off the unit before operating.
• Remove the plug of the water outlet opening and
keep it in safe area.
• Securely and properly connect the drain hose. Make
sure it is not kinked and clear of obstruction.
• Place the outlet of hose over a drain or bucket and
ensure that water can freely flow out of the unit.
• Do not submerge the end of hose into water; other-
wise it can cause "Air Lock" in the hose.
INSTRUCTION MANUAL · AIR CONDITION
Press the Timer key
è
to turn on the timer
function.
Press the Timer key
è
to turn on the timer
function.
Press Up /Down repeatedly until the LED shows '00'.
Note: by pressing POWER you will also cancel the
è
timer
16
Press Up /Down
è
repeatedly to set the
delay OFF time.
Press Up /Down
è
repeatedly to set the
delay ON time.
Remove the
rubber sealing plug
Continuous drain hose