Attach The Exhaust Hose - Wilfa Chill Connected AC1W-7000 Instructions

INSTALLATION
CHOOSE YOUR LOCATION
• If tipped more than 45°, allow the unit to set upright for at least 24 hours
before start up.
• Place the unit on a firm, level surface in an area with at least 50cm of free
space around it to allow for proper air circulation.
• Do not operate in close proximity to walls, curtains, or other objects that may
block air inlet and outlet. Keep the air inlet and outlet free of obstacles.
• Never install the unit where it could be subject to:
– Heat sources such as radiators, heat registers, stoves or other products that
produce heat.
– Direct sunlight
– Mechanical vibration or shock
– Excessive dust
– Lack of ventilation, such as a cabinet or bookcase
– Uneven surface
WARNING!
• Install the unit in rooms which exceed 8 m².
• Do not install the unit in a place where inflammable gas may
leak.

ATTACH THE EXHAUST HOSE

The air conditioner requires being vented outside so that the exhaust air can
escape the room which coming from the appliance contains waste heat and
moisture.
Do not replace or extend exhaust hose which will result in decreased efficiency,
even worse shut down the unit due to low backpressure.
Step 1: Connect the hose connector to one end of the exhaust hose.
CHILL CONNECTED · AC1W-7000
11
EN