Ventilating Your Room; Sleep Mode - Wilfa Chill Connected AC1W-7000 Instructions

• Press SPEED button repeatedly until the desired fan speed indicator lights up.
• To control the direction of the air flow horizontally, please adjust the inner
louver by hand.
Note: The air conditioner stops if the room temperature is lower than selected
temperature.

VENTILATING YOUR ROOM

• Press MODE button repeatedly until the FAN indicator lights up.
• In ventilation mode the room air is circulated, but not cooled.
• Press SPEED button repeatedly to select the fan speed as desired.
DRYING YOUR ROOM
• Press MODE button on the control panel or remote control, the dry indicator
lights up. The fan speed is unable to select. User should connect the hose to
the drain outlet at the bottom of the unit.
Note: In this mode, the fan speed switches over to low speed and cannot be
selected.

SLEEP MODE

• The sleep button can only be set in cooling mode.
• The machine enters sleep mode, all lights are dimmed at the same time,
and the buzzer is disabled in sleep mode:
– 1 hour after sleep mode is turned ON, the set temperature will automat-
ically increase by 1°C, and after another hour, the set temperature will
automatically increase by 1°C.
• After sleep mode has been ON for 2 hours, the set temperature will no
longer increase.
• Fan output during sleep mode: the fan automatically turns to low setting.
The wind speed output is low wind and cannot be adjusted. After exiting
sleep mode, the wind speed can again be set by the user.
CHILL CONNECTED · AC1W-7000
15
EN