Sleep Operation - Airwell AWSI-HHF009-N11 Manuel D'utilisation Et D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

A guide on using the infrared remote is not
included in this literature package.
the functions are available for the air
conditioner, please check the indoor display
and remote control of the unit you purchased.
Other Features
Auto-Restart(some units)
If the unit loses power, it will automatically
restart with the prior settings once power has
been restored.
Anti-mildew (some units)
When turning off the unit from COOL, AUTO
(COOL), or DRY modes, the air conditioner will
continue operate at very low power to dry up
condensed water and prevent mildew growth.
Wireless Control
Wireless control allows you to control your air
conditioner using your mobile phone and a
wireless connection.
For the USB device access, replacement,
maintenance operations must be carried
out by professional staff.
Louver Angle Memory(some units)
When turning on your unit, the louver will
automatically resume its former angle.
Refrigerant Leakage Detection
(some units)
The indoor unit will automatically display "EC"
or "EL0C"or flash LEDS (model dependent )
when it detects refrigerant leakage.
Page 9
Not all
(some units)

Sleep Operation

The SLEEP function is used to decrease
energy use while you sleep (and don't
need the same temperature settings to
stay comfortable). This function can only
be activated via remote control. And the
Sleep function is not available in FAN or
DRY mode.
Press the SLEEP button when you are
ready to go to sleep. When in COOL mode,
the unit will increase the temperature
by 1°C (2°F) after 1 hour, and will increase
an additional 1°C (2°F) after another hour.
When in HEAT mode, the unit will decrease
the temperature by 1°C (2°F) after 1 hour,
and will decrease an additional 1°C (2°F)
after another hour.
The sleep feature will stop after 8 hours and
the system will keep running with final
situation.
SLEEP Operation
Cool mode(+1 C/2 F) per hour
for the first two hours
Set
temperature
1hr
Heat mode( -1 C/2 F) per hour
for the first two hours
Saving energy during sleep
Keep
running
1hr

Publicité

Table des Matières
loading

Table des Matières