Technical Data - ATIKA WS 225 Notice Originale

► Fold the sanding head holder (8) open.
► Pull out the extraction hose (6).
► Insert the new extraction hose as shown into the
sanding head holder.

Make sure that the ring (h) rests in the groove (f).
► Close the sanding head holder with the screws.
► Place the extraction hose with the mounting clip (7)
on the receiver (g) and tighten the clip.
Never sand without extraction hose since dust ex-
traction will otherwise not work.
Replacing the carbon brushes

Replace the carbon brushes once they have been worn
down to approx. 4 mm.
► Remove the carbon brush cover (22) on the side of
the motor cover by turning it counter clockwise using a suit-
able screw driver.
► Remove the carbon brushes; note the position of the
spring retention.
► Insert the new carbon brushes (23) observing the correct
position of the spring retention.

Replace the carbon brushes only in pairs.
► Screw in the carbon brush cover (22) again.
Type / Model
Year of construction
Motor power P
1
Motor
Speed n
0
Sanding disc Ø
Sanding disc receiver
Sanding pad Ø
–
Length device (min. max.)
Exhaust connection -Ø
Length extraction hose
Hand/arm vibration on the handle
–
(according to EN 60745) Sanding with sanding disc
Measuring uncertainty K
Measured sound power level L
Measuring uncertainty K
Pressure level L (according to EN 60745)
PA
Measuring uncertainty K
Safety class
Protection calss
Weight
20
All manuals and user guides at all-guides.com

Technical data

(according to EN 60745)
WA
Care

Observe the following to maintain the operability of the
machine:
 Clean all moving parts regularly.
 Remove dust and dirt using a soft brush or a dry cloth.
 Do not clean the machine with running water or high-
pressure cleaners.
 Do not use solvents for the synthetic parts (petrol, alcohol,
etc.) as these can damage the synthetic parts.
 Keep handles dry and free of oils and grease.
Water, solvents and polishing agents shall not be
applied.
 Make sure that the vent slots of the engine's cooling fins for
engine cooling are free (risk of overheating).
Storage
Pull out power plug
Store unused products in a dry, locked place out of the

reach of children.
 Before a longer period of storage carry out the following to
'
extend the machine s service life and ensure an easy operat-
ing:
 thoroughly clean the device
Guarantee
Please observe the enclosed terms of guarantee.
WS 225
See last page
710 W
AC-motor 220 - 240 V ~ 50 Hz
0 - 1200 min
225 mm
Hook-and-loop fastener system
215 mm
~ 1340 -1700 mm
35 mm
1 m
a = < 1.428 m/s²
vhw
1.5 m/s²
99.9 dB (A)
3 dB (A)
88.9 dB (A)
3 dB (A)
II / double insulated
IP 20
3.8 kg
-1