Use For The Intended Purpose - BWT AQA drink Pro 20 CAS Instructions De Montage Et De Service D'origine

3.1 USE FOR THE INTENDED PURPOSE

This BWT AQA drink Pro 20 water dispenser may only be fed with cold water of a drinking water
quality. Any other use is regarded as not in accordance with the intended purpose. The AQA
drink Pro 20 is a water dispenser which is connected directly to the drinking water supply. Un-
limited access to clean drinking water is thus available (depending on the filter capacity). Ideally,
the water dispenser can be combined with BWT filter technology for perfect enjoyment thanks
to the water's enrichment with Magnesium.
3.2 CONSTRUCTION AND FUNCTION OF THE AQA DRINK PRO 20
The AQA drink Pro 20 water dispenser offers three different water options:
» CAS: cooled and still, room temperature and still, cooled with CO
Fig. 1 shows the AQA drink Pro 20 water dispenser.
The following elements are included on the front:
1
3
Fig. 1: Front view of the AQA drink Pro 20 CAS
After the water dispenser has been installed (Chapter 5), the required type of water can be cho-
sen. Place a glass on the grid of the drip tray under the water outlet and choose the required
type of drinking water by pressing one of the selection buttons. The control panel for the CAS
device is shown in fig. 2.
22
All manuals and user guides at all-guides.com
2
1. LED indicators
2. Selection buttons
3. Drip tray
2
4. Water outlet
4
Fig. 2: Control panel of the AQA drink Pro 20 CAS
» LED indicator COLD is on when the cold water function is on: cooled water is available.
» LED indicator CO is on when the CO function is on: carbonated water (with CO
2 2
» LED indicator UV is on when the UV lamp is on: UV lamp is functional.
» UV LED indicator flashes when the UV lamp is not working or is not connected.
The rear panel of the AQA drink Pro 20 CAS water dispenser has the following connections
(fig. 3):
4
1
2
3
5
Fig. 3: Rear panel of the AQA drink Pro 20 CAS
cooled water, still
room temperature water, still
carbonated water with CO
2
) is available.
2
1. On/off switch for the cooling function
(COLD)
2. On/off switch for the carbonator pump
(CO )
2
3. Power connection
4. CO connection (CO INLET)
2 2
5. Water connection (WATER INLET)
23