Before Use - aidapt VG832 Mode D'emploi

INTRODUCTION
Thank you for deciding to purchase the Canterbury Mobile Multi-Table from Aidapt. This
product is manufactured from the finest material and components and, when used and
maintained correctly, is designed to give many years of reliable trouble-free service.
NB. This equipment must be installed by a competent person.
VG832 Self Assembly
VG866 Fully Assembled
15 kg weight limit.
Do not exceed the weight limit stated – doing so could damage the equipment or put
the user at risk.

BEFORE USE

Carefully remove all packaging. Avoid using any knives of other sharp instruments as this
may damage the surface of the product.
Check the product for any visible damage If you see any damage or suspect a fault, do not
use your product, but contact your supplier for support.
CONTENTS
Wood finished table top with integrated chrome plated tubes
•
Painted tubular 'H' section with black threaded locking nuts x 2
•
Stainless Steel 'L' shaped brackets
•
U-shaped base with two short uprights
•
'E'-clips x 2
•
ASSEMBLY INSTRUCTIONS
1. Carefully unpack your Canterbury Table and examine all parts for any damaged or,
loose fitments. Should you find any fault, please return your table to your supplier
for exchange.
2. After inspection, place the wooden finished table-top face down onto a soft
surface to avoid scratches and raise both the fixed chrome plated tubes vertically
and level.
3. Take the two painted tubular sections with the black threaded locking nuts
attached and slide these OVER each of the chrome plated tubes with the black
locking-nuts facing downward towards the table top. Tighten the threaded nuts
onto the chrome plated tube.
4. The black locking nuts are designed to be tightened onto the chrome tubing,
allowing the tabletop to be put at any height or angle without the risk of collapse
under its intended use. However the design of this unit is only meant to be
Fixing and Maintenance Instructions
2
Ver. 5 10/2013 (1327)