aidapt VG832 Mode D'emploi page 3

adjusted to a 'finger tight' pressure, over tightening of the locking nut could result
in the plastic housing being damaged.
5. If already installed, remove the E clips from uprights on the U shaped base.
6. Take the U shaped base with the two welded painted tubular uprights with pre
punched locating holes and place the welded tubular uprights into the two tubular
sections (fig. 1).
7. Ensure the pre punched holes align with the holes found on the two painted
tubular sections. You may have to loosen the black locking nuts, be sure to
retighten the black locking nuts once you have achieved the alignment.
8. Insert the two E shaped clips provided through the pre punched holes, ensure that
the E clip is fully located (fig. 2). FAILURE TO DO SO WILL MAKE THE TABLE
UNSTABLE.
N.B. Please note that over tightening the nuts in this way will invalidate the
warranty on this item, as this is misuse of the intended application.
9. Turn your table over with the U section on the floor and your table is now ready for
use . If you wish to angle the top you can do so by up to 45o. To achieve the
desired angle release the black locking nut furthest away from you and raise the
tabletop to the desired height, then retighten the black locking nut to avoid the
top sliding back downward.
Fixing and Maintenance Instructions
3
Ver. 5 10/2013 (1327)