Quick Start - NEC AccuSync LCD51VM Manuel

Quick Start

To attach the Base to the LCD Stand:
1. Insert the front of the LCD Stand into the holes in the front of the Base.
2. Next, position the locking tabs on the back side of the LCD Stand with the holes on the
Base. Lower the Stand until locking tabs are secure.
To attach the AccuSync LCD monitor to your system, follow these instructions:
1. Turn off the power to your computer.
2. For the PC with Analog output: Connect the 15-pin mini D-SUB signal cable to the
connector of the display card in your system (Figure A.1). Tighten all screws.
For the MAC: Connect the AccuSync Macintosh cable adapter to the computer, then
attach the 15-pin mini D-SUB signal cable to the AccuSync Macintosh cable adapter
(Figure A.2). Tighten all screws.
NOTE: To obtain the AccuSync Macintosh cable adapter, call NEC-Mitsubishi Electronics
Display of America, Inc. at (800) 632-4662.
3. Connect the 15-pin mini D-SUB of the video signal cable to the appropriate connector
on the back of the monitor (Figure B.1). Connect the audio cable to AUDIO-INPUT on
the back of the monitor and the other end to the "Audio out" terminal of the computer.
Headphones may be connected to the "Headphones" output on the back of the
monitor " ". While the headphones are connected, the sound from the speakers will
be disabled. Headphones can be purchased from your local electronics store.
4. Connect one end of the power cord to the LCD and the other end to the power outlet.
Place the video signal cable and power cord between the cable holder (Figure B.1).
NOTE: Adjust the position of cables between the holder to avoid damage.
NOTE: If you use this monitor at AC125-240V, please refer to Recommended Use
section of this manual for proper selection of power cord.
5. Turn on the monitor with the front power button and the computer. (Figure C.1)
6. No-touch Auto Adjust automatically adjusts the monitor to optimal settings upon initial
setup for most timings. For further adjustments, use the following OSM
• Auto Adjust Contrast
• Auto Adjust
Refer to the Controls section of this User's Manual for a full description of these
OSM controls.
NOTE: For download information on the Windows
monitor, refer to the References section of this User's Manual.
NOTE: If you have any problems, please refer to the Troubleshooting section of this User's Manual.
AS5171VMManual042403.p65
Stand
1
2
Locking Tabs
Front Base
Base
® 95/98/Me/2000/XP INF file for your AccuSync
3
3
controls:
®
5/6/03, 10:06 AM