Additional Information; Optional System Settings; System Setup Menu Options In Standby - Pioneer XV-DV333 Mode D'emploi

Additional information

Chapter 11
Additional information

Optional system settings

These settings are accessed by using the
System Setup menu while in standby.
1 Switch the system into standby.
2 Press SYSTEM SETUP .
3 Use to choose the setting you want
to adjust then press ENTER .
The current setting is shown for each option as
you cycle through the display. See below for a
full list and description of each.
4 Use to adjust the setting.
5 Repeat steps 2 and 3 to make other
settings then press ENTER to confirm.

System Setup menu options in standby

Below are all the available settings in the setup
menu. The first setting in each is the default.
System demo setting
Switches the automatic demo feature on or off
(this starts when you plug in for the first time):
• Demo On – Switches the demo feature on.
• Demo Off – Switches the demo feature off.
Key lock setting
The Key Lock feature is useful when you've set
the wake-up timer and don't want the system
switched on before it activates.
Note
1 After setting the clock, the demo mode switches off automatically. However, if you unplug the system from the wall outlet, the
demo mode will revert to Demo On (and the clock will be reset).
2 Most models of the newly developed countdown PAL TV system detect 50 Hz (PAL)/60 Hz (NTSC) and automatically switch
vertical amplitude, resulting in a display without vertical shrinkage. However, in some cases, the image may appear without col-
or. If your PAL TV does not have a V-Hold control, you may not be able to watch NTSC discs because of picture roll. If the TV has
a V-Hold control, adjust it until the picture stops rolling. On some TVs, the picture may shrink vertically, leaving black bands at
the top and bottom of the screen.
All manuals and user guides at all-guides.com
• Lock On – Makes the front panel buttons
• Lock Off – Restores regular use of the
Clock format setting
Specifies how the clock is displayed:
• 12-Hour – Display shows 12-hour format.
• 24-Hour – Display shows 24-hour format.
TV / Line attenuator settings
If the source connected to the AV
CONNECTOR (TV) or LINE1 (L1) analog input
is distorting, the attenuator will reduce the
signal level.
• ATT 6dB – Reduces signal level by 6dB.
• ATT 10dB – Reduces signal level by 10dB.
• ATT Off – No attenuation
TV system setting
The default setting of this system is AUTO, and
1
unless you notice that the picture is distorted
when playing some discs, you should leave it
set to AUTO. If you find picture distortion with
some discs, set the TV system to match your
country or region's system. However, this may
restrict the kinds of disc you can watch. See
the table for the kinds of discs compatible with
each setting (AUTO, PAL and NTSC).
• After using
and controls inoperative.
front panel buttons and controls.
to choose TV Sys (step 3
above), press ENTER to change the TV
system as follows:
11
2
35
En