Power Supply; Directions Of Breast Pump Using - weewell WPB900 Mode D'emploi

• Hold the high side of the locker (figure 9)
• Aim the low side of locker at the gap in the round hole in the electric connector (figure 10).
• Press the exchange locker into the hole steadily. There will be crack sound (figure 11).
• Rotate the locker anticlockwise and clockwise to check whether or not it is installed well.

Power supply

• The electric breast pump can be run either with batteries or, using the adapter.
• For batteries operation you need four 1.5 V batteries, type AA. Make sure the batteries are
the right way round.

Directions of breast pump using

• Rotate the suction adjuster dial to the maximum left position (figure 12).
Place the breast into the breast shield cup (figure13), with the nipple centered and
•
sealed to the nipple protector (3) (figure14), to create a vacuum. Please ensure there
are no air gaps between the nipple and the nipple protector, as well the breast and the
breast shield cup.
• Plug the unit into power or insert batteries and turn the switch in the motor unit to 'on' to
start the motor.
• Turn the dial at the front of the motor unit between 'L' and 'H' to get the proper suction
(figure 12).
• Press the 'Mode' button to get the most proper rhythm (figure 15).
◊ The pre-set mode is "Gentle". The suck lasts for 2 seconds. The mode light is blue colour.
◊ Press one time, the mode is "Normal". The suck lasts for 3 seconds. The mode light is con-
fused of blue and red.
◊ Press two times, the mode is "Express", the suck lasts for 5 seconds. The mode light is red
◊ Vaccum release lasts for 3 seconds for every mode.
8 I WPB900 USER MANUAL
All manuals and user guides at all-guides.com