Maintenance And Environmental Protection; Service Instructions - MeisterCraft MKR 1400 L Traduction Du Manuel D'utilisation Original

5453680-Handkreiss-man 30.01.14 07:17 Seite 47
Make sure the polarity (+/–) is correct.
You will need 2 x 1.5 V alkaline batteries
of type Micro/AAA.
Adjusting the laser optic (14)
Set the cutting angle setting to 90°/0°,
place the shoes on an even surface and
switch on the laser projector. In this
position, the laser beam must run
parallel to the cutting direction, over
notch A, 90°/0°, Figure 3. If this is not
the case, release the two screws on the
laser optic, and position the optic
appropriately. Then tighten the screws
again.
Dust extractor (10)
The vacuum connection enables
you to extract the dust using a
vacuum cleaner. Breathing in
dust is dangerous, and you should
therefore always work with the vacuum
system activated.
10 – Maintenance and
environmental protection
The ventilation slots on the engine
housing should be kept free and clean.
Blow the build up from the slots from
time to time.
CAUTION! Electrical and battery
operated units that no longer work
should not be disposed of in the house -
hold waste! They are to be collected
separately, in accordance with the
2012/19 EU directive for
the disposal of electrical
and electronic waste, and
sent for proper and
environmentally-friendly
recycling.
All manuals and user guides at all-guides.com
Please discard power tools no longer
usable at a local collection point.
Collection and disposal of packaging
materials separately by types complying
with local rules and regulations. For
details, please contact your municipal
authority concerned.
11 – Service instructions
• Store the machine, operating
• MeisterCRAFT devices are to a large
• MeisterCRAFT devices are subject to
• A brief description of the defect
• In so far as a repair under guarantee
claim!
instructions and where necessary the
accessories in the original packaging.
In this way you will always have all
the information and parts ready to
hand.
extent maintenancefree, a damp cloth
being sufficient to clean the casing.
Do not drop electrical machines in
water. Please note additional hints
given in the operating instructions.
stringent quality control. If however a
functional fault shoult occur, send the
device to our servicing address. The
repairs will be carried out in a short time.
speeds up the faulttracing and repair
time. If within the guarantee period,
please enclose the guarantee
document and the proof of purchase.
is not concerned, we will charge the
repair costs to your account.
PLEASE NOTE! Opening of the
device invalidates the guarantee
IMPORTANT! We point out
expressly that in accordance
47