Operation; Mode Of Operation - MeisterCraft MKR 1400 L Traduction Du Manuel D'utilisation Original

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 26
5453680-Handkreiss-man 30.01.14 07:17 Seite 46
5. Clean the flange, insert a new blade.
Pay attention to the direction the
blade runs in (see the arrow on the
protective cover).
6. Tighten the hexagonal screw, ensure
device is running correctly.
7. Set the splitting wedge.
8 – Operation
Switching on and off
Fig. 7
The machine has a two button security
switch mechanism: The machine can
only be put into operation if the handle
is held firmly and both buttons are
pressed. When the handle is released,
the machine switches off automatically
to ensure that accidental operation is
not possible.
CAUTION! When starting up this
piece of equipment, a brief
interruption in voltage may occur,
particularly when the power supply
quality is not good. These interruptions
may affect other items (e.g. cause a
light to flicker). With a power supply
impedance of Z
interruptions are not to be expected.
(Please contact your local power supply
provider for more information).
46
All manuals and user guides at all-guides.com
2
< 0.451 OHM,
max
9 – Mode of operation
• The pendulum cover is automatically
pushed back by the work piece.
• Gently and evenly push the circular
saw forwards.
• The waster piece should be located
on the right-hand side of the circular
saw to ensure that the largest piece is
lying fully on the table.
Laser projector (13)
Fig. 8
15
13
The beam from the laser project makes
it easier to carry out straight cuts
a) along a pre-drawn cutting line on the
work piece
b) or by pointing it at a marked fixed
point on the work piece.
The range of the beam is approximately
65 cm, depending on the ambient
lighting.
The laser projector is switched on/off as
required using the on/off button (15).
Changing the battery
Remove the battery compartment
cover (16) of the laser projector (13).
Always replace used batteries in pairs.
14

Publicité

Table des Matières
loading

Table des Matières