Set-Up And Take-Down Instructions - Eskimo EVO 2 Manuel De L'opérateur

SETUP & TAKEDOWN INSTRUCTIONS
Step 1 • [ FIGURE 16 ]
Pull the shelter skin out and extend the underlying
framework poles. NOTE: An audible "click" will notify
you when the (#21950) pole is fully extended.
Step 2 • [ FIGURE 17 ]
Unfold the shelter skin and locate the front panels.
Step 3 • [ FIGURE 18 ]
Pop-out both front panels by pulling on the straps attached to
each of the hubs.
CAUTION
BE CAREFUL NOT TO SNAG ANY FRAMEWORK DURING
THIS POP-OUT PROCESS. FAILURE TO DO SO COULD CAUSE
DAMAGE TO THE SHELTER SKIN.
Step 4 • [ FIGURE 19 ]
Locate the roof hub and pull upwards to pop-out the roof panel.
Step 5 • [ FIGURE 20 ]
Enter the shelter and install the back spreader poles (#22004) to
(#21950) and the sled, as shown in Figure 10 earlier in this manual.
Step 6 • [ OPTIONAL ]
Install high wind poles (#22612) into the front (top and bottom)
corners of the shelter. NOTE: Pockets for the wind poles are
marked with reflective patches.
Step 7 • [ FIGURE 21 ]
Anchor the shelter to the ice using provided ice anchors, drilling
them through the grommet sewn into the skirt in the sequence
shown in Figure 18.
FIGURE 21
8
TOW ROPE
Check for parts online at www.GetEskimo.com or call 800-345-6007 M-F 8-5 CDT
|
22200, 25502
EVO™ Crossover Ice Shelter
FIGURE 16
FIGURE 17
FIGURE 18
FIGURE 19
FIGURE 20
Operator's Manual