[ FIGURE 10 ]
10.
Assemble back support poles by clipping back
support poles (#22004) to frame pole (#21950),
then insert swaged end into hole provided on
back-center lip of plastic sled.
SHELTER SKIN INSTALLATION
NOTE: Locate skin assembly (#21947 / #24565) in plastic
bag. Remove from the bag and unroll. Within the rolled
skin you will find (2) high wind poles (#22612) and a
pouch of ice anchors. Save these for the set-up section
of this manual.
[ FIGURE 11 ]
11.
Locate front panels of the skin assembly (these will
have a large Eskimo logo and large trapezoidal
windows), then pull the hub strap until the shelter
panel pops open. Repeat the process for the top roof
panel.
[ FIGURE 12 ]
12.
With all three panels popped open, lift the rear of the
top panel and pull the shelter skin over the assembled
sled and pole assembly.
[ FIGURE 13 ]
13.
Rest the rear of the top panel on assembled
frame pole assembly.
[ FIGURE 14 ]
14.
Attach the skin assembly to the frame pole assembly
using the velcro straps sewn at the rear of the top
panel seam. There will be (4) individual velcro
attachments at this location [(2) at center, and (2)
at the corners)].
NOTE: Once the skin is attached to the frame pole
assembly, make sure all the fabric panels are laying flat
and the skin assembly is centered in front of the sled.
EDGE TRIM ATTACHMENT
[ FIGURE 15 ]
15.
Locate the center of the edge trim (#22270) by
folding it in half. Next, locate the center rear of the
shelter along the sled lip and attach the edge trim
center at that center point.
Be sure to keep the skin taut as you work the
remainder of the edge trim into place around the
sled corners. Screw in place with (12) 6 x 3/8 screws
provided, spaced evenly.
Check for parts online at www.GetEskimo.com or call 800-345-6007 M-F 8-5 CDT
22200, 25502
FIGURE 10
FIGURE 11
FIGURE 13
BACK OF SLED/SKIN
EDGE TRIM
SKIRT
SKIN
#6 - 3/8" SCREW
SLED
EDGE TRIM
Operator's Manual
|
EVO™ Crossover Ice Shelter
#22004
FIGURE 12
FIGURE 14
FIGURE 15
7