Eskimo EVO 2 Manuel De L'opérateur page 6

[ FIGURE 7 ]
7.
Assemble Table (#11331) to Front Seat
Loop (#21999) using: (2) ¼ - 20 x 1½" bolts
(#48240), (1) ¼ - 20 x 2¼" bolt (#48271),
and (3) ¼" washers (#48261). Insert bolts
through the tubing and the bottom of the
table with threads up.
NOTE: Table (#11331) features built-in "t-nuts"
for ease of assembly. Make sure ALL bolts are
properly engaged before tightening down any
specific bolt.
[ FIGURE 8 ]
8.
Assemble Hinge (#22003) to Plastic Sled
using: (4) ¼ - 20 x 1" bolts (#69345), (8) ¼"
washers (#48261), and (4) Nyloc nuts
(#67538).
You may now tighten all hardware used
*
during this portion of the assembly.
SUPPORT POLE INSTALLATION
[ FIGURE 9 ]
9.
Assemble the Pole Frame (#21950) by
sliding part (#21950) over the Hinge Pole
upright (#22003). Push the brass button on
the Hinge Pole to allow the Pole Frame to
pass over. You will hear a click when the
frame pole locks into the user position.
Now press the tabs on the red pole frame
ends and slide the pole frame down the
hinge poles. When completely collapsed,
this is in the travel position.
6
#11331
FIGURE 7
FIGURE 8
FIGURE 9
Check for parts online at www.GetEskimo.com or call 800-345-6007 M-F 8-5 CDT
|
22200, 25502
EVO™ Crossover Ice Shelter
Operator's Manual
#22003
#21950