Shelter Skin Installation - Eskimo Sierra Mode D'emploi

#27825
#27821
(27727/27728)
ASSEMBLY
10
Assemble last (27727/27728) assembly and #27821 to
#27825 using (2) 2-1/2 IN Phillips drive bolts, (2) nuts,
and (4) nylon/plastic washers as shown in Figure 11.
#27729
#27825
(27727/27728)
ASSEMBLY
12
(A) Attach #27729 to (2) Front (27727/27728) assemblies as
shown in FIGURE 13. Be sure to fully extend both (27727/27728)
assemblies until locked prior to attaching #27729.
(B) Adjust length of #27729 to position (27727/27728)
assembly so that it resembles FIGURE 13, using #27825 as a
reference for the angle.
TIP: Once the skin has been fully assembled to the frame and
sled, using a permanent marker, make a locating line that can be
easily seen for faster set-up when on the ice.
8
SEE
DETAIL
#27729
Check for parts online at www.GetEskimo.com or call 800-345-6007 M-F 8-5 CDT
Operator's Manual | Flip-Style Sled Shelter
25300 Sierra™
SKIN ASSEMBLY
11
(A) Attach #27730 to #68380 and (27727/27728)
as shown in FIGURE 12. Be sure to fully extend
(27727/27728) assembly until locked prior to
attaching #27730.
(B) Adjust height of #27730 until it is straight up
and down.
#27480 / #27481
13
Work the #27480 / #27481 (depending on model) skin
assembly over the poles and rest it on the aluminum
framework.
|
25250 Sierra™ Thermal
(27727/27728)
ASSEMBLY
#27730
#68380