Lowering The Platform; Emergency Lowering - Upright MX15 Guide De L'opérateur

Operation
L
O W E R I N G T H E
1. Turn the Lift/Drive Switch to
2. Check around the base of the platform to ensure that no one is in contact with the machine. Engage the
Interlock Switch and pull back on the Control Handle to lower the platform.
3. The platform will stop when it reaches the PPE cutout height. Inspect around the machine to ensure no
one is in contact with the machine. After a four-second time delay, lower the platform as in step 2.
E
M E R G E N C Y
W A R N I N G
!
If the platform should fail to lower, NEVER climb down the elevating assembly.
Stand clear of the elevating assembly while operating the Emergency Lowering Valve Knob.
The Emergency Lowering Valve Knob is located
beside the ladder at the rear of the machine.
1. Open the Emergency Lowering Valve by pulling
and holding the knob.
2. To close, release the knob. The platform will not
elevate if the Emergency Lowering Valve is open.
Page 10
All manuals and user guides at all-guides.com
P
L A T F O R M
.
L
O W E R I N G
!
Figure 4: Emergency Lowering
Emergency
Lowering
Valve Knob
113100-020 - MX15 / MX19 - Operation Manual