English
ATTENTION:
CAUTION:
Injury to persons and damage to the
lamp and/or the mounting surface
may result if the lamp is pulled from
the surface. To reduce the likelihood of
such injury or damage, mount only on
a surface that is mechanically sound.
English
WARNING
Deviation from the assembly
instructions may result in a risk of fire
or electric shock.
English
This device complies with part 15 of the
FCC Rules. Operation is subjected to
the following two conditions:
1. This device may not cause harmful
interference, and
2. this device must accept any
interference received, including
interference that may cause undesired
operation.
WARNING
Changes or modifications not expressly
approved by the party responsible
for compliance could void the user's
authority to operate the equipment.
2
English
CAUTION
To reduce the risk of fire, electric
shock, or injury to persons: Use only
insulated staples or plastic ties to
secure cords. Route and secure cords
so that they will not be pinched or
damaged when the cabinet is pushed
to the wall. Position the portable
cabinet light with respect to the
cabinet so the lamp replacement
markings can be read during
relamping. Not intended for recessed
installation in ceilings, or soffits. The
low-voltage portable cabinet light may
be installed inside or under a kitchen
cabinet or other built-in furniture
when:
1. The low-voltage Class 2 power supply
is located outside the cabinet and is
not concealed; and
2. The line voltage power supply
cord is not concealed or run through
openings in the cabinet, walls, ceilings,
or floors. This requirement does
not apply to the wiring between the
cabinet light and the power unit. The
National Electric Code (NEC) does
not permit cords to be concealed
where damage to insulation may go
unnoticed. To prevent fire danger, do
not run cord behind walls, ceilings,
soffits, or cabinets where it may
be inaccessible for examination.
Cords should be visually examined
periodically and immediately replaced
when any damage is noted.
AA-2056562-4