Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
User Manual
Installation
Important! Before starting the installation, please ensure that all devices are powered off.
The following steps are for an installation using HDMI equipment, if you are using DVI
equipment you should substitute the HDMI cables for DVI to HDMI cables where required.
1. Connect your HDMI source to the Fibre Optic Transmitter device using a HDMI cable
(maximum length 5m).
2. Remove the dust covers from the Fibre Optic Transmitter and Receiver ports and your SC
Fibre Cable.
3. Connect one end of the multi-mode SC duplex 50/125 µm fibre cable (maximum length
300m) to the optical port on the Transmitter and the other end to the optical port of the
Receiver. Please ensure that the SC connectors are fully engaged before proceeding.
4. Use another HDMI cable (maximum length 5m) to connect your HDMI display/projector/sink
device to the HDMI port on the Receiver.
5. Plug the DC power supplies into the HDMI transmitter and receiver, respectively.
6. Power on your HDMI Source and Display to complete the installation.
As well as extending a HDMI signal the Fibre Optic Extender can also repeat IR remote
commands / signals, with the use of the optional IR Repeater Kit (LINDY Number 38006),
allowing you to control your HDMI source whilst up to 300m away. Simply connect the IR
Repeater Transmitter and Receiver to the relevant ports on the Fibre Optic Transmitter and
Receiver. This functionality is provided in addition to HDMI CEC, which is also supported by this
extender.
Troubleshooting
There is no display on the screen.
Check that the DC plugs and jacks used by external power supplies (both the extender units
and others) are firmly connected.
Check that the SC Fibre Connectors are plugged in correctly and that the Link Status LED is
lit.
Check that the HDMI source and display are both powered on and active
Power off all the devices, then power on in this order:first, the transmitter and receiver
modules, then the display and finally the source.
Make sure you have not mixed up the SC Duplex fibres with each other at one end.
Reduce
the
length
All manuals and user guides at all-guides.com
of
HDMI
cable
3
used,
or
use
a
English
higher
quality
cable.
Publicité
Table des Matières
