AERMEC VMF-E4X Manuel D'installation page 10

CHOICE OF TEMPERATURE PROBE
The E4X panel allows the user to select, via a software parameter, the reference temperature probe for the adjustment of the E0/E1/
E19/E19I thermostat.
Position of temperature probes
The figure shows an example of installation in which there is a fan coil (master) controlled by the E4Xpanel. In this case, the probes that detect
the room temperature are positioned on the panel and the fan coil.
To adjust the room temperature by means of the thermostat, one of the following three configurations can be selected.
SET OFF
+
To select the suitable configuration for the specific installation, just perform the three following operations:
AUTO
OFF
SET
SET OFF
AUX
+
+
1) hold the ( ) key down for 5 seconds, passing to the "choice of the type of regulation" mode;
AUTO
AUTO
AUX SET MODE OFF
AUX
SELECT +
2) Use the ( ) and ( ) keys to modify the type of regulation;
AUTO
MODE
MODE
SELECT
AUX
SELECT
3) Press the key ( ) to confirm the choice and go back to the "environment control" mode;
MODE
SELECT
Note: to use the area control and enabling of the pump by the centralised system (BMS/VMF-E5/VMF-E6) this parameter must be set
in C1 or C3 mode.
10
VMFE4XLJ-0821 - 6795769_03
Regulation with probe present on VMF-E4X;
Regulation with probe present on fancoil;
Regulation with average value between the two probes;
Adjustment with probe on board panel E4Xwithout filtering software;
Adjustment with average value between the probe on board fan coils and value E4X probe without filtering
software;