Installation - Westinghouse QR0313 Manuel De L'utilisateur

Installation

DRILLING THE PILOT HOLES
- Draw a vertical line (1) on the supporting wall up to the
ceiling, or as high as practical, at the center of the area in
which the hood will be installed .
- Draw a horizontal line (2) at 18 in. (458 mm) above an
electric stove or 29.5 in. (750 mm) above a gas stove.
- Place the chimney support bracket (E) on the wall about
0.8 in. (20 mm) from the ceiling or upper limit, aligning the
center notch with the vertical reference line (1) . Mark the
wall at the center of the holes in the bracket (E) .
- Place the hood brackets (D) on the wall, aligning their
center notches 11.2 in. (284 mm) above the horizontal line
(2) and 5 .36 in . (136 mm) apart . Mark the wall at the center
of the holes in the bracket .
- Drill pilot holes at the marked locations .
INSTALLING THE TOGGLE BOLTS AND CHIMNEY
SUPPORT BRACKET
- Screw the four toggle bolts (AA) into the wall, leaving the
head of the bolts approximately 0.25 in. (6.4 mm) away
from the wall surface .
- Place the chimney support bracket (E) over the upper
toggle bolts (AA) . Tighten securely .
0.25 in
(6.4 mm)
AA
All manuals and user guides at all-guides.com
Wall
E
D
2
ATTACHING THE HOOD BRACKETS
- Attach the two hood brackets (D) to the back of the
range hood (A) with the four screws and washers (BB) .
A
10
Ceiling
0.8 in. (20 mm)
5.36 in. (136 mm)
11.2 in.
(284 mm)
1
18–29.5 in.
(458–750 mm)
D
BB
BB