Changing The Lamp - AirKing ECQ Serie Manuel D'utilisation

3. Install the included 8 watt LED lamp into the lamp holder by lining up the pins on the
lamp base to the socket of the lamp holder and turning the lamp body clockwise until the
lamp snaps into place and is firmly seated in the lamp holder. Install a 4 watt maximum
type C7 (candelabra base) night light (not included) into the side lamp holder and reinstall
the lamp cover by squeezing the cover's sides and fitting them into the slots on the hood.
4. Turn switches to the "OFF" position and restore power. Test that the light and the fan are
operating properly.
5. If there is any vibration noise, check for the source and try to tighten fasteners or adjust
the tape to make a tighter connection or seal.
SECTION 10
Controls
Your Range Hood is equipped with two rotary switches with one controlling the lighting and
the other controlling the exhaust fan. The light switch has three positions, Main Light ( ● ),
Night Light ( ◗ ), and OFF ( ■ ). The fan switch has three positions, High, Low, and OFF.
Choosing any speed setting will override the continuous operation of the hood. Once the hood
is set to the OFF ( ■ ) position on the main control panel, the continuous operation speed will
once again engage.
To turn the continuous operation speed off, you will need to remove the wire compartment
cover and locate the rocker switch labeled "ASHRAE 62.2" on the speed selection cover.
Selecting the OFF position will turn the continuos speed function off. The hood will still operate
when speeds are selected through the main control panel.
WARNING:
SWITCHING THE CONTINUOUS SPEED ROCKER SWITCH
TO THE OFF POSITION DOES NOT TURN THE MAIN POWER TO THE HOOD OFF.
SECTION 11
Maintenance
CAUTION:
SERVICE PANEL BEFORE SERVICING THE UNIT.
Filters
Grease Filter - Included with your range hood are aluminum grease filters that should
1.
be washed at least once a month. The filters are dishwasher safe and should be washed
in a mild soap or detergent. Reverse the instructions in the "Finishing the Installation"
section of the instructions to remove filters. If the grease filters become damaged,
replace with Air King Model GF-01 Grease Filters.
6728061 Rev. K 9-19
MAKE SURE POWER IS SWITCHED OFF AT

Changing the Lamp

1. Remove the lamp cover by squeezing in the sides. The cover is held in place by tension
against the tabs on the hood.
LED Lamp: Remove lamp by gently twisting counterclockwise to release the lamp from
the base. Installation is the reverse of removal. Replace with Air King model AK8LED40 or
a compatible GU24 8 watt LED lamp.
Night Light: Unscrew night light bulb from socket and replace with a 4 watt maximum
type C7 (candelabra base) night light bulb.
Fuse
1. To replace the fuse, turn the fuse cap located next to the wire connector counter
clockwise and pull out. Replace with only a 125-Volt fuse, 1-1/2 Amp Max. Reinstall the
fuse back into the hood.
Cleaning
CAUTION:
CLEANSERS, ETC., AS THEY MAY DAMAGE THE RANGE HOOD.
1. Clean your range hood with a mild detergent, such as dishwashing liquid, and dry with a
soft cloth. NEVER USE ANY ABRASIVE PADS OR SCOURING POWDERS. Completely dry
before restoring power. NEVER IMMERSE ELECTRICAL PARTS IN WATER.
2. The fan assembly can be vacuumed when build up (dirt, lint, etc.) accumulates over time.
The fan is permanently lubricated and does not require oiling.
www.airkinglimited.com
DO NOT USE GASOLINE, BENZINE, THINNER, HARSH
4 of 12