Protection Functions; Over-Temperature Protection - Klarstein TRINITYCOOK HYBRID Mode D'emploi

EN
34
4. The power setting is shown on the cooking zone display (5). When you set the
temperature, the cooking zone display (5) shows "C" and the temperature display
(8) shows the set temperature.
5. After you have set the temperature or power level, touch the timer button
the timer while the cooking zone control lamp above the cooking zone display (5)
is still fl ashing. The timer setting and the set temperature are shown alternately on the
timer/temperature display (8).
6. If "E0" is shown on the cooking zone display (5), the induction hob has not
detected any ferromagnetic metal cookware, which means that the cookware used
is unsuitable. Use cookware made of ferromagnetic metal.
CAUTION
Risk of burns! The accessible surfaces of the appliance can become very
hot during operation.

PROTECTION FUNCTIONS

Over-temperature protection

The appliance is equipped with a temperature sensor device to monitor the temperature
inside the hobs. When an excessive temperature is detected, both the Induction Hob
and the Hi-Light Ceramic Hob will stop increasing temperature automatically.
Detection of small articles (Induction Hob)
When the Induction Hob detected the existence of a pot which is less than 80 mm in
diameter or small articles (e.g. knife, fork, forceps, key, etc.) or non-magnetic pots (such
as aluminium or bronze pot), the buzzer can gives out an alarm lasting about 1 minute.
In case user has not put proper pot in time, the Induction Hob shall automatically switch
to standby mode.
Residual heat after use
When the hob is used for a long period of time, heat remains in the heating zone for a
few minutes.
Auto shutdown protection
Auto shutdown is a safety protection function of the appliance. If not turned-off after
120 minutes, it will shuts down automatically.
to set