TROUBLESHOOTING – English
*Important probe readings variations:
Clean and grease the connectors.
Clean probe and redo calibration.
Cable is cut, replace probe.
*Valve and motor are not working:
Check power supply.
Clean sugar sand.
*Motor is working but not the valve:
Check the assembly, retighten nuts.
Worn gear. Replace motor.
*Valve does not open when you press ''MAN''
There is a 2 second delay before valve opening. To keep valve open you need to hold
"MAN" button down
*Syrup at the evaporator outlet does not have the right Brix degree:
Check the boiling point of water, readjust temperature set point.
Page 14 sur/of 14