GYS PANORAMIC 3XL Mode D'emploi page 5

The welding helmet PANORAMIC 3XL complies with EEC directives 89/686 CEE. This confirmity is established in compliance with EN 175, EN 166, EN 168 and EN 379.
Notified bodies / organisations :
Cell :
Identification number : 0196
This welding helmet is delivered ready for use. For your protection, please read carrefully these instructions and consult with a qualified instructor prior to operation.
BEFORE WELDING
-Check that the welding helmet is in good condition and headband adjustment.
-Check whether the front cover lens, the front frame and filter are inserted and fixed in place. In case of anomalie, please proceed to its reconditionning.
-Make sure that the 4 sensors (7) and the 2 cells (6) are not obstructed by dust or debris.
-Make sure that the protection films on both screens are removed.
-Make sure that the red light (4) is off, otherwise change the batteries (10).
-Check that the protection level matches your welding processes. Please refer to the following chart to help your choice (cf. welding process board)
OPERATION
The PANORAMIC 3XL auto-darkening welding helmet switches from light to dark state when a welding arc is struck. The auto-darkening welding helmet switches back to the
light state when the arc stops.
1 2
3 4
5
• Internal sensitivity potentiometer : Sensitivity adjustable according to :
- Light ambient: Without welding, turn the sensitivity setting towards «max», then turn the sensitivity setting towards «low» until filter lightens.
- Welding process: «Max» position for low amperage TIG rpocess / Medium range for most application.
• Internal delay potentionmeter: Controls the delay for the helmet to switch back to clear after welding.
Delay is designed for slower switching time to clear state to eliminate remained bright rays.
The internal shade range selector allows to choose the shade range between 4-8 or 8-12.
The external potentiometer allows to adjust the shade according to the selected shade range.
• "GRIND" knob : For non-welding operation, you can switch off the filter on « Grind » mode. The Grind led will blink to confirm the filter is off.
WARNING: To be protected before welding, carefully check the switch to be on WELD mode
PRECAUTIONS
• The welding helmet is suitable for use with virtually all welding processes except Oxy-Acetylene welding, laser welding and gas welding.
• Standard protective screens must be installed on both inside and outside surfaces of the module. Failure to use protective screens may constitute a safety hazard or result in
irreparable damage to the module.
HEADBAND ADJUSTMENT
The PANORAMIC 3XL is equipped with a headband which can be adjsuted in multiple ways to suit the welder: width, height (1), longitudinal inclination (3) and adjustment (2).
EN
Welding hood / Protection
screen :
11
8
6
9
7
8
Clear shade
4
Dark shade 4-8 / 8-12
Filter dimension
114 x 133 x 9 mm
Reaction speed 0,0002 s
Power supply
Solar + batteries
Weight 610 gr
Field of vision
131 x 84 mm + 2x (67 x 75) mm
Applications MMA 5>400 / TIG 2>300 / MIG-MAG 5>400 / Grind
Warranty
1 year
Application temperature -5°C / + 55°C
Storage temperature
-20°C / + 70°C
Identification number : 0196
1. Sensitivity control knob
2. Delay time control knob
3. Shade adjustment 4-8/8-12
4. Shade adjustment «WELD» / «GRIND
5. Potentionmeter «Welding-Grinding»
6. Low battery alarm
7. LCD protection plate
10
8. Solar cell
9. Sensors
10. Filter
11. Pile lithium 3V (x2) CR2032
5