Pattfield Ergo Tools PE-AFR 18 Li Traduction De La Notice Originale page 230

Fit the guard hood (Fig. 5/Item 6) as shown in Figure 5 and secure
with 2 screws (Fig. 5/Item. 15).
Fit the brush (Fig. 6a/Item A) onto the drive axle (Fig. 6a/Item B).
Make sure that the brush fi ts accurately into the mount (Fig. 6a/Item
C). The shaft must be fi xed in order to fasten the brush. To do so, in-
sert the pin (Fig. 2/Item 10) into the recess on the shaft (Fig. 6b) and
hold with one hand. Using the open-ended wrench (Fig. 2/Item 11),
tighten the nut (Fig. 6b/Item 12).
Important! Be sure to remove the pin again from the shaft.
To dismantle the equipment for changing the brush proceed in rever-
se order.
5.2 Height adjustment (Fig. 7)
Undo the union nut (Fig. 7/Item 5) until the paving scraper's handle
can be moved in and out freely. Now set the required working height
and secure the handle in this position by tightening the union nut
again.
GB
5.3 Adjusting the additional handle (Fig. 8)
Undo the adjustment lock (Fig. 8/Item 3) for the additional handle un-
til it can be moved forwards and backwards without any great resis-
tance. Set the required position and tighten the securing screw again.
5.4. Installing the battery (Fig. 9/10)
Press the side pushlock button of the battery pack as shown in Fig. 9
and push the battery pack into the mount provided. When the battery
is positioned as in Fig. 10, make sure that the pushlock button lat-
ches in place! To remove the battery pack, proceed in reverse order.
5.5 Charging the battery (Fig. 11)
1. Take the battery pack out of the equipment. Do this by pressing
the side pushlock buttons.
Anl_PE_AFR_18_Li_SPK7.indb 230 Anl_PE_AFR_18_Li_SPK7.indb 230
All manuals and user guides at all-guides.com
- 230 -
13.10.2016 15:23:56 13.10.2016 15:23:56