Dremel 220 Consignes De Fonctionnement/Sécurité page 10

DM 2610921728_220 4/12/16 11:16 AM Page 10
accessories, or storing power tools. Such preventive safety measures reduce the risk of
starting the power tool accidentally.
WORKSTATION IS DESIGNED FOR USE
ONLY WITH DREMEL ROTARY TOOL
MODELS 100, 200, 275, 285, 300, 395, 398,
400, 800, 3000, 4000, 8100, 8200, 8220, 4200
and 4300.
Your Dremel Workstation 220 will convert
rotary tools to a drill press for drilling, to a tool
holder for sanding or polishing, or to a flex
shaft tool stand.
time. Do not hang a tool on hanger assembly
when another tool is mounted in the press.
The Crow's Nest tool storage (Fig. 12) will
hold the following tools:
• Drill bit set (Model 628 or 631)
• Rotary tool wrench
• Mounting wrench
• Bits with shank size less than or equal to 1/8"
• Rotary tool collets
(Models 480, 481, 482, 483)
Drill Press
Instructions
NOTE: The drill bits are held in the tool by a
collet system or Dremel 3-jaw chuck. The bit
may be installed before or after the rotary tool
is installed in the drill press.
1. Insert and secure the drill bit into Dremel
rotary tool. See your rotary tool manual for
Operation
Disconnect the plug from the power source and/or the battery pack
from the power tool before making any adjustments, changing
For illustrations refer to pages 2 - 6
Workstation is for use
with only one tool at
detailed instructions (Fig. 13).
2. The Depth Stop is used when you wish to
drill holes to a measured depth. A scale on
the press housing is provided for your
convenience.
Set the depth stop adjustment to the
desired depth and tighten depth stop lock
knob 9D (Fig. 16). Four set screws 9E are
also provided on the depth gauge and left
side of the housing assembly (See Fig.
16). These screws allow for micro
adjustments to the action of the drill press.
Use small flathead screwdriver to tighten or
loosen the movement of the press. Be
carefull not to overtighten set screws.
3. The small Angle Lock knob 10 and large
Angle Lock knob 11 are used to secure the
tool either vertically or at a 90° angle. Tool
may be used at a 15°, 30°, 45°, 60°, 75° or
90° angle for off axis drilling applications
(Fig. 16).
Loosen the large and small knobs and
rotate the tool, then securely tighten both
angle lock knobs.
4. The Height Adjustment Lever 7 is used to
secure the press on the tube at the proper
height (Fig. 16).
Loosen the lever and move the press/tool
assembly to the desired position, then
tighten the height adjustment lever.
5. Mark the hole locations on the workpiece
-10-